![]() Note: Some accessory wires do no have rubber molded ends. The wire numbers are found in the manual and references the color codes that are found on the wiring harness.The back of the switch is marked as follows:īATT- #21 yellow wire, supplies voltage to the switch.ĪCC – #30 black with green – fuel and temp gauge, #8 orange with yellow – turn signal, also attached is other accessories radio heater, etc. The 1957 portion of the manual on page 99 corrected the drawing except for View F.Īll three years use the same switch and the wires are connected the same. ![]() It shows the post for the start wire (red/blue) #32 on the outer circumference of the switch with the other three post instead in the center as it was original made. The wiring is correct but the drawing of the back side of the ignition switch for the 1955 on page 18 and the 1956 on page 57 is not correct. The manual has been reproduced and is available from CTCI, item number110-25. ![]() The wiring diagram can be confusing, especially the ignition switch, for anyone using the FoMoCo Electrical Equipment Installation Manual for the first time. ![]() Gil Baumgartner CTCI Authenticity Chairman ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |